DynaColor Lite H.264 DVR Guia de preparacion descargar pdf (Pagina 4)

Network Setup

Configure the LAN setup for the DVR to properly function with Ethernet connection.

 From OSD main menu, select <System Setup>  <Network Setup>, set the <LAN Select>

item to <LAN> or <PPPoE> according to the network application, and enter <LAN Setup>.

 For DHCP user, set the DHCP to <ON>. The IP address, Netmask, Gateway and DNS settings

are retrieved from network servers. DHCP is dynamic that the settings change from time to time.

 For Non-DHCP user, set the DHCP to <OFF>. Enter an IP address, Netmask, Gateway, and

DNS settings. Please obtain the information from the network service provider.

 To change the IP address, Netmask, Gateway and DNS value, press UP/DOWN keys to move

the cursor to the item. Use LEFT/RIGHT keys to access each section of the value and press

ENTER, then change the value using UP/DOWN keys.

 PPPoE users must set the <PPPoE Account>, <PPPoE Password> and <PPPoE Max Idle>

as well.

 When the settings are complete, press ENTER to confirm and save the settings; or ESC to

abort.

Dome Camera Control

Dome Camera Connection & Settings:

 See section Pin Definition of Alarm I/O & RS-485, and Audio In for RS-485 port pin definition.

 Refer to the following figure. Connect the R+, R- terminals on the dome camera to the D+, D-

terminals on the RS-485 port by RS-485 cable respectively.

 To set up dome camera’s protocol and ID, press MENU to access the OSD main menu, and

select <Camera Setup>. Then select <Dome Protocol> and choose the corresponding

protocol. Next select <Dome ID> and choose a preferred ID number. Note that the ID number

must match the ID address defined by the dome camera.

 To configure the RS-485 parameters, select <System Setup> from OSD main menu, and then

select <RS485 Setup>. The default RS-485 settings are 9600 Baud, 8 Data Bits, 1 Stop Bit and

No Parity.

1 2 3 4 5 6 7 8 9 10

Sin comentarios

DynaColor Lite H.264 DVR Guia de preparacion Pagina 4