DynaColor Lite H.264 DVR Manual de usuario descargar pdf (Pagina 53)

DVR User’s Manual

NOTE: The settings become effective after saving the changes and

exiting from the menu.

4.5.3 RS485 Setup

The DVR controls the dome cameras via RS-485 communication protocol.

The RS-485 parameters of the DVR must be set to the same as the

parameters set in dome camera.

Users are allowed to change the RS-485 settings of the DVR. Select

<System> in Main menu, then select <RS485 Setup> from the System setup

menu and press ENTER. The following menu is displayed.

RS485 Setup

Unit ID

Baud Rate

Bits

Stop

Parity

224

9600

None

Unit ID number must match the ID address set by the dome camera. The Unit

ID is in the range of 1 to 255. Note that there cannot be any two devices on

the same bus given the same ID address, or a conflict may occur.

NOTE: The settings become effective after saving the changes and

exiting from the menu.

4.5.4 Dome Controlling Key

After pressing DOME to enter Dome Control mode, a dome control panel will

be displayed. The controlling buttons are: Iris Close/Open, Focus Far/Near,

Zoom Out/In, Preset, Live, Pan/Tilt Speed, Direction buttons, and Auto Focus.

The functions are described as below.

Iris Close

Click on it to close the Iris on the dome camera.

Iris Open

Click on it to open the Iris on the dome camera.

Focus Far

Click on it to focus the lens of selected dome camera at a farther point.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 83 84

Sin comentarios

DynaColor Lite H.264 DVR Manual de usuario Pagina 53