DynaColor DH701 Guía de instalación descargar pdf (Pagina 11)

Installation Guide

3. Camera Setups and Cable Connections

Before installing or connecting the Dome Camera, please refer to this section

and complete preparations for dome setups and various switch settings.

There will be a PE cloth sheet covered inside the dome cover and a lens cap

on the lens for shipping protection. Follow the steps below to remove those

protective materials.

Step 1: Unpack the dome package and take out the dome body.

Step 2: Rotate and remove the protective cover.

Step 3: Remove the PE cloth sheet and take off the lens cap.

Step 4: Attach the dome cover to the dome body.

3.1 Dome Camera Setups

Before connecting the Dome Camera to other devices of CCTV system,

please complete the Dome Camera’s ID and communication switch settings.

These switches are located on the bottom of the Dome Camera.

3.1.1 Switch/Connector Definition

Configuring the Dome Camera’s ID and communication protocol are required

before connecting the analog camera to other devices. The switches used for

configuring these settings are located on the bottom of the Dome Camera.

Additionally, the 22-Pin Connector for Data Cable connection and ISP

Connector for firmware upgrade kit connection are located on the back plate

of both analog and network Speed Dome Cameras. Please refer to the

diagrams and tables accompanied with for use of each switch/connector.

Please refer to the diagrams and tables of switch/connector definition below.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 64 65

Sin comentarios

DynaColor DH701 Guía de instalación Pagina 11