DynaColor DH701 Guía de instalación descargar pdf (Pagina 13)

Installation Guide

3.1.2 Communication Switch Setting

Communication Switch SW 1

SW 2

RS-485 Setting

SW 3

Termination

SW 4

Line Lock

SW 5

Factory Default Reset

SW 6

Reserved

RS-485 is the interface that communicates the Dome Camera and its control

device; for this reason, the RS-485 setup of the dome and the control device

must be the same. The RS-485 default setting is half-duplex (see the diagram

follows). Please do not change the default setting without qualified specialist

or supplier’s notice. As for the SW 3 and SW 4, they are used for termination

and Line Lock adjustment respectively. The SW 5 is mainly used when users

want to restore the camera to the factory default status; moreover, once

firmware upgrade is carried out, users also need to reset the SW 5 afterward.

RS-485 Setting

Half-duplex

Full-duplex

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 64 65

Sin comentarios

DynaColor DH701 Guía de instalación Pagina 13