DynaColor QIG-510 Series Guía de instalación descargar pdf (Pagina 11)

Installation Guide

3. Camera Setups and Cable Connections

Before installing or connecting the Dome Camera, please refer to this section

and complete preparation, switch setting and communication switch settings.

3.1 Dome Camera Setups

Before connecting the Dome Camera to other devices of CCTV system,

please complete the Dome Camera’s ID and communication switch setting.

These switches are located on the bottom of the Dome Camera. Additionally,

the 22-Pin Connector for Data Cable connection and ISP Connector for

firmware upgrade kit connection are located on the back plate of both analog

and network Speed Dome Cameras.

3.1.1 Switch Definition

Please refer to the diagrams and tables accompanied with for use of each

switch/connector.

Analog Model Network Model

Camera Control Protocol Switch

None

Communication Switch

Communication Switch (Reserved)

None

RJ-45 Connector

22-Pin Connector

ID Switch

None

Reserved F-1 Reboot Button

ISP Connector (for FW upgrade)

F-2 Factory Reset Button

ISP Connector (for FW upgrade)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 58 59

Sin comentarios

DynaColor QIG-510 Series Guía de instalación Pagina 11