DynaColor QIG-510 Series Guía de instalación descargar pdf (Pagina 13)

Installation Guide

3.1.3 ID Setup

Please change the analog Dome Camera’s ID if there is more than one Dome

Camera in the same network. Use the switch to change your Speed Dome

Camera’s ID by setting the 10-bit dip switch. For instance, if the camera’s ID

is 006, set the SW 8 and SW 9 to “ON,” with the rest to “OFF,” as shown

below.

For switch configuration details, please refer to Appendix B: Switch Settings

Index Table in the Dome Camera’s User Manual.

NOTE: No two Dome Cameras should be given the same ID, or

communication conflict may occur.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 58 59

Sin comentarios

DynaColor QIG-510 Series Guía de instalación Pagina 13