DynaColor QIG-510 Series Guía de instalación descargar pdf (Pagina 12)

Installation Guide

The ID and Protocol numbers of an analog camera are set with a 10-bit and

6-bit dip switch respectively using binary system. For switch configuration

details, please refer to Appendix B: Switch Settings Index Table in Mini Speed

Dome Camera’s User Manual.

NOTE: Please NO NOT change the factory default Communication

Switch settings of the network Speed Dome Camera.

3.1.2 Communication Switch Setting

The analog Dome Camera’s communication switches are specified in the

table below.

Communication Switch SW 1

SW 2

RS-485 Setting

SW 3

Termination

SW 4

Line Lock

SW 5

Factory Default Reset

SW 6

Camera Upgrade

RS-485 is the interface that communicates the Dome Camera and its control

device; for this reason, the RS-485 setup of the Dome Camera and the

control device must be the same. The RS-485 default setting is half-duplex

(see the diagram follows). Please do not change the default setting without

qualified specialist or supplier’s notice. As for the SW 3 and SW 4, they are

used for termination and Line Lock adjustment respectively. The SW 5 is

mainly used when users want to restore the camera to the factory default

status; moreover, once firmware upgrade is carried out, users need to reset

the SW 6 afterward.

RS-485 Setting

Half-duplex

Full-duplex

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 58 59

Sin comentarios

DynaColor QIG-510 Series Guía de instalación Pagina 12