DynaColor SL H.264 WD1 Información técnica descargar pdf (Pagina 43)

OSD Setup Manual

 Detection Configuration

If <Motion Detection> is enabled, the motion detection parameters should be setup.

Select a channel in <Channel Select>, and then click <Detection Config>. The

Detection Configuration menu displays as follows.

Detection Config

Detected Area Setup

Sensitivity

Area Threshold

88%

- Detected Area Setup

The Detected Area, consisting of 192 (16×12) detection grids, is

displayed as below. Follow the steps to setup the detected area.

 Click and drag the mouse to select or de-select a detection area. A

pull-down list will be displayed after the mouse is released.

 Select <Block Select> to set the grid(s) as a motion detection area,

or select <Cancel> to abort.

 Then, right click the USB mouse, another pull-down list, which

include <Select All>, <Deselect All>, and <Confirm>, will be shown.

 Click on <Select All> to select all grids as motion detection area.

Alternatively, select <Deselect All> to deactivate all grids.

 After the setting is completed, right click and select <Confirm> to

save the setting, and return to the <Detection Config> menu.

- Sensitivity

This item is used to set the sensitivity of detection grids. A greater

value indicates more sensitive motion detection. A motion alarm will be

triggered once the amount of motion detected area exceeds the

Threshold value.

Adjust the value by clicking the UP / DOWN buttons next to

<Sensitivity>. The value is increased by 4% increment.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 67 68

Pepe 04 Oct 2024 | 16:28:51

Nada

DynaColor SL H.264 WD1 Información técnica Pagina 43